Hey guys!
I wasn't sure if this goes into the ''product questions'' section because it's not a T11 product.
Anyway, I just got a [larger] porper clip from E and the clip is VERY bent inwards. Like I mean there must be a solid 1mm/2mm gap in between the distance from end to end. On to the question. I wanted to know if I should physically grab the clip and bent it so it's flat. Otherwise I'm going to have a hell of a time trying to get my cards in and out.
Thanks,
Mehar
I wasn't sure if this goes into the ''product questions'' section because it's not a T11 product.
Anyway, I just got a [larger] porper clip from E and the clip is VERY bent inwards. Like I mean there must be a solid 1mm/2mm gap in between the distance from end to end. On to the question. I wanted to know if I should physically grab the clip and bent it so it's flat. Otherwise I'm going to have a hell of a time trying to get my cards in and out.
Thanks,
Mehar